How To Maintain The Plastic Mold Toolings?
Leave a message
How To Maintain The Plastic Mold Toolings?
--Deep Mould
First, the maintenance of plastic mold before production
Before the mold is produced, the oil on the surface of the mold must be cleaned. The rust is cleaned and cleaned to see if there is any foreign matter in the cooling water hole of the plastic mold. Is there a waterway?
Second, the maintenance of plastic molds in production
1. Clean the foreign body glue wire, foreign matter, oil, etc. of the mold parting surface and the exhaust groove and check whether the thimble of the mold is abnormal and regularly oil.
The parting surface and the flow surface are cleaned twice a day. Guide the tip, bushing, and position of the tip to feed the oil once a day.
2. Check the water path of the mold regularly and tighten all the fastening screws.
3, Check whether the limit switch of the mold is abnormal, oblique pin. Whether the oblique top is abnormal.
Third, the maintenance of plastic molds during shutdown.
Before stopping the machine, the cooling water circuit must be closed, the remaining water in the water pipe in the mold should be blown off, and the residual rubber wire should be checked on the outer surface of the mold. The foreign matter should be cleaned and cleaned, and evenly sprayed with anti-rust agent to accurately fill in the relevant records.
Then take the injection mold toolings to the fixed position in the storage,keep the mold toolings' surface dry and clean.
They will wait until the next production without problem.These are little details,but it is important for the whole progress of plastic mold tooling production. Or not,it may cause cost additional,lead time delay.For our customers,time is money,we always keep these points in mind.
